Restore an earlier version with Revisions
Revisions keep earlier versions of each project when you save, and the Revisions view brings one back as the project’s draft. Revisions are included with a LayerSlider license.
On this page
Restore an earlier version
The version you restore becomes the project’s draft, and your site keeps showing the published version until you click Publish.
Open the project in the Project Editor.
In the toolbar, across the top, move the pointer over the History menu and choose Revisions.
The Revisions view opens across the bottom of the editor.
You can also choose Revisions in the ⋮ menu of the toolbar, in the top right corner of the editor.
In the Revisions view, click the left arrow, or drag the control that runs from your oldest revision to Now, until the canvas shows the version you want.
The canvas shows the project as it was at the revision you choose. - Warning
Applying a revision replaces the version in the editor, saved or not. If the canvas changes when you click the left arrow once from Now, no revision holds that version: to keep it, click Exit Revisions and publish it first.
Click Apply Selected Revision.
The editor reloads with the version you chose. When you’re ready to show it on your site, click Publish. You can also press CtrlShift ⇧S.
Undo a restore
Before you publish the restored version, the published version is still there: choose Revert to Original in the ⋮ menu of the toolbar to go back to it.
If you already published the restored version, the revisions from before the restore are still in the Revisions view. There, step back until the canvas shows the version you had, and apply it.
Undo doesn’t take a restore back: after the reload, it steps back through the edits saved with the version you restored.
If no license is registered on the website
Without a registered license, choosing Revisions in the editor opens a window about the license instead of the Revisions view. Register your license to turn Revisions on. From then on, LayerSlider keeps revisions when you save or publish. To bring back work from before then, use the other ways back.
If the project has no revisions
If the Revisions view says “No revisions are available for this project yet.”, there’s no revision to restore. Revisions are made only while your license is registered and Revisions are turned on, and not at every save. Two other ways can still bring back earlier work.
Undo, next to the History menu, takes back your changes to the slide you’re editing, one step at a time. You can also press CtrlZ. To go back several steps, move the pointer over the History menu and choose a step in the History List: the steps after it are undone. The steps are saved with the project, so they’re still there after you reopen it. Changes made in Project Settings aren’t among them.
If you saved changes that you haven’t published, Revert to Original in the ⋮ menu of the toolbar opens the published version.
What Revisions keep
By default, LayerSlider makes a revision when you save or publish, at most one every 10 minutes, and keeps up to 100 revisions of each project. Beyond 100, each new revision deletes the oldest.
To change these numbers, open the Revisions view and then the Revisions Settings menu, beside Exit Revisions. Create Revisions After sets the minutes, and Revisions per Project sets how many revisions each project keeps. The settings apply to every project on your website.
Turning off the Enable Revisions switch, in the same menu, stops new revisions and opens the alert “Delete saved revisions?”. To keep the revisions you have, click Cancel: the switch stays off.